Seat Leon 1.8 Cupra R Front J Hook Brake Discs and EBC Ultimax2 Pads


  • Front Axle Set
  • Halo J Hook Slotted Brake Discs
  • EBC Ultimax2 Brake Pads (With Wear Wire)

2 in stock (can be backordered)

SKU: BDK1124 Category:


  • Brake Disc Diameter 323mm (Brembo fitment)
  • Thickness 28mm
  • Height 34mm
  • Spigot Diameter 65mm
  • PCD 5 x 100mm

Brake Pads supplied will have the wear indicator wire.

HALO J Hook Slotted Brake Discs (PAIR)

Give you vehicle a fresh modern sporty look with our J Hook slotted brake discs, slotted brake discs help to reduce brake fade by give the gas that is built up between the brake pad surface and brake disc surface an area to escape thus allowing a more constant pressure between the discs and the pads.

Road and Track Use

HALO brake discs perform on the road and on the track but as you can imagine the temperatures achieved on the track are usually much higher than seen under normal road use, if using on the track it’s important that extra care is taken during fitment and post fitment.

  • Ensure the hubs are cleaned before fitment
  • Ensure there is no excess free play in wheel bearings
  • Ensure the brake discs are running true before use by measuring run-out
  • Ensure the brake caliper pistons and slides are move freely checking slides for wear
  • Ensure tightening torques are adhered too

Post Fitment

After fitment and road-testing re-check the wheel torque, this is especially important when using on track use after several laps, as the heat absorbed by the brake discs will transmit through to the wheel hub and wheel, this causes your components to expand and may lead to reduced wheel tightening torque. This will lead to brake vibrations when braking and may permanently damage your brake discs and ruin your track day enjoyment. Please note however we do not offer warranty for use on track.

EBC Ultimax2 Brake Pads

  • This is what Ultimax2™ brake pads deliver…
  • Superb daily driver R90 type approved pad.
  • Features red “brake in’ surface coating for instant safe braking after install.
  • New 100 % ECO friendly material with ZERO sulphides.
  • No shims for noise reduction needed.
  • More bite from cold.
  • Works in hot and dry climates as well as in cold.
  • Fully R 90 approved as was the original Ultimax grade


Additional information

Weight 25 kg

HALO Performance

Placement on Car



BD1490D, FDB1896